Powercommender V

Power Commander V Product Introduction

The New Power Commander V is loaded with tons of new features. Below you will find some Power Commander V features.

  • Reduced size from PCIIIusb (less than half of the size of PCIII)
  • USB powered from computer (9 volt adapter is no longer needed for programming)
  • 2 position map switching function built in (map switch not included)
  • Gear input (allows for map adjustment based on gear and speed)
  • Analog input (allows user to install any 0-5 volt sensor and build an adjustment table based on its input such as boost or temperature)
  • With gear position input connected the PCV is capable of allowing each cylinder to be mapped individually and for each gear (for example: on a 4 cylinder bike with a six speed transmission there could be up to 24 separate fuel tables).
  • Unit has a -100/+250% fuel change range (up from -100/+100%). This allows more adjustment range for 8 injector sportbikes
  • 10 throttle position columns (up from 9 on PCIIIusb)
  • Enhanced “accel pump” utility (increased adjustment and sensitivity ranges)

NEW Power Commander V w/ Built in Ignition Control


NEW Power Commander V w/ Built in Ignition Control


On select models, gain control over fuel delivery AND timing with the new Power Commander V with fuel and ignition control. The best of both worlds, now you can realize all the benefits of the Power Commander V and the Ignition Module 5 wrapped in a single enclosure. This Power Commander V is available for select twin cylinder engines.

  • Retains all of the standard Power Commander V fuel control features
  • Allows +/- 20 degrees of timing adjustment
  • Map Switch Input – change maps on the fly
  • Adjust timing per cylinder
  • Raise your Rev Limit (only available on select models)
  • Built In Launch Limiter